Replacing The Roller Drive Motor Assembly; Tools Required; Removing The Drive Roller Motor Assembly - Kodak CR 360 Service Manual

Service Guide

Replacing the Roller Drive Motor Assembly

Tools Required

• 3.0 mm Allen wrench
• 1.0 mm Allen wrench

Removing the Drive Roller Motor Assembly

[1] Disconnect the scanner from the main power.
[2] Remove the scanner cover. (See
[3] Move the PM assembly into the drum.
[4] Disconnect the white roller drive motor connector from the connector panel.
Note
There are two types of washers, flat and spring. The washers must be removed and installed in order.
64
Removing the Scanner Cover on Page 25.)
Screw
Motor encoder board
6H4869