Replacing The Power Supply; Tools Required; Removing The Power Supply Unit - Kodak CR 360 Service Manual

Replacing the Power Supply

Tools Required

• Power supply kit (SK000088)
• Long-shaft 7 mm socket wrench
• Long-shaft 2.5 mm Allen wrench
• Phillips (cross-head) screwdriver

Removing the Power Supply Unit

Note
After installation of the new power supply, mark the number 1 in the modification label located at the back of the
scanner.
[1] Disconnect the scanner from the main power.
[2] Remove the scanner cover. (See
[3] Loosen the 2 Allen screws retaining the U bracket.
[4] Slide the bracket to the side.
[5] Remove the black plastic cover.
6H4869
Removing the Scanner Cover on Page
Service Procedures
25.)
Allen screw
U bracket
Plastic
cover
Allen screw
71