Alignment Of The Main Drive Motor - Kodak M35 Service Manual

Alignment of the Main Drive Motor

[1] Remove the drive SIDE PANEL, the
2 GUARD SCREWS, and the CHAIN GUARD.
[2] Loosen the 3 SETSCREWS.
[3] Align the SPROCKETS with the ends of the
DRIVE SHAFT and the MOTOR SHAFT.
[4] Tighten the 3 SETSCREWS.
[5] Check that the DRIVE CHAIN does not touch
the MOUNTING PLATE.
[6] Check that the SPROCKET on the DRIVE
SHAFT does not touch the DRIVE GEAR on
the DRYER RACK. See the illustration on
page 2-16.
[7] Install the CHAIN GUARD, the 2 GUARD
SCREWS, and the SIDE PANEL.
2-18
SETSCREW (3)
SPROCKET (2)
MOTOR
SHAFT
DRIVE
CHAIN

Alignment of the Main Drive Motor

DRIVE
SHAFT
MOUNTING
PLATE
H112_0088CCA
H112_0088CC
981777