Reset Provision Failed-Config - HP Enterprise FlexFabric 12900E Series Command Reference Manual

Syntax
provision [ subslot subslot-number ] model model
undo provision [ subslot subslot-number ] model
Default
Preprovisioning is disabled.
Views
Slot view
Predefined user roles
network-admin
Parameters
subslot subslot-number
subslot, preprovisioning is enabled on the slot. To specify a subslot, you must first enable
provisioning on the slot and make sure the provisioned slot has subslots.
model model
To obtain available models, enter a question mark (?) for the
Usage guidelines
CAUTION:
• When you disable preprovisioning on a slot, the device removes all preconfigured settings for the
slot, including the preconfigured settings for the subslots.
• When you disable preprovisioning on a subslot, the device removes preconfigured settings for
the subslot.
This command allows you to enable preprovisioning on offline interface cards or subcards.
The device automatically creates interfaces when preprovisioning is enabled for an interface card or
subcard. The
card or subcard comes online.
Examples
# Enable preprovisioning for the LSXM1SUPER1 module on a slot.
<Sysname> system-view
[Sysname] slot 2
[Sysname-slot-2] provision model LSXM1SUPER1
Related commands
display provision failed-config

reset provision failed-config

slot
reset provision failed-config
Use
reset provision failed-config
records.
Syntax
reset provision failed-config
: Specifies a subslot by its subslot number. If you do not specify a
: Specifies the card, IRF member device, PEX, or subcard model to be preprovisioned.
display interface
command will not display these interfaces until the interface
to clear preprovisioned-commands application failure
198
argument.
model