Telnet Server Ipv6 Dscp - HP Enterprise FlexFabric 12900E Series Command Reference Manual

Syntax
telnet server ipv6 acl { ipv6 | mac } acl-number
undo telnet server ipv6 acl
Default
No IPv6 ACL is used to filter IPv6 Telnet logins.
Views
System view
Predefined user roles
network-admin
Parameters
: Specifies an IPv6 ACL.
ipv6
mac : Specifies a Layer 2 ACL. To specify an ACL of a different type, do not specify this keyword.
acl-number
this argument is 2000 to 3999. If you specify the
4000 to 4999.
Usage guidelines
You can specify an ACL that does not exist for this command. However, this command takes effect
only after you create the ACL and configure rules for the ACL. For more information about ACL, see
ACL and QoS Configuration Guide.
If you execute this command multiple times, the most recent configuration takes effect.
This command does not take effect on existing Telnet connections.
Examples
# Permit only the user at 2000::1 to Telnet to the device.
<Sysname> system-view
[Sysname] acl ipv6 basic 2001
[Sysname-acl6-ipv6-basic-2001] rule permit source 2000::1 128
[Sysname-acl6-ipv6-basic-2001] quit
[Sysname] telnet server ipv6 acl ipv6 2001

telnet server ipv6 dscp

Use
telnet server ipv6 dscp
to a Telnet client.
Use
undo telnet server ipv6 dscp
Syntax
telnet server ipv6 dscp dscp-value
undo telnet server ipv6 dscp
Default
IPv6 uses the DSCP value 48 for Telnet packets sent to a Telnet client.
Views
System view
: Specifies an ACL by its number. If you specify the
to specify the DSCP value for IPv6 to use for Telnet packets sent
ipv6
keyword, the value range of this argument is
mac
to restore the default.
78
keyword, the value range of