Ftp Client Source - HP Enterprise FlexFabric 12900E Series Command Reference Manual

The source address specified with the
connections. The source address specified with the
connection that is being established.
Examples
# Specify the source IPv6 address of 2000::1 for FTP packets sent to an IPv6 FTP server.
<Sysname> system–view
[Sysname] ftp client ipv6 source ipv6 2000::1
Related commands
ftp ipv6

ftp client source

Use
ftp client source
server.
Use
undo ftp client source
Syntax
ftp client source { interface interface-type interface-number | ip
source-ip-address }
undo ftp client source
Default
No source IPv4 address is specified for FTP packets sent to an IPv4 FTP server. The device uses the
primary IPv4 address of the output interface for the route to the server as the source address.
Views
System view
Predefined user roles
network-admin
Parameters
interface interface-type interface-number
number. The device will use the interface's primary IPv4 address as the source address. For
successful FTP packet transmission, make sure the interface is up and has the primary IPv4 address
configured.
ip source-ip-address
make sure this address is the IPv4 address of an interface in up state on the device.
Usage guidelines
If you execute this command multiple times, the most recent configuration takes effect.
The source address specified with the
specified with the
The source address specified with the
connections. The source address specified with the
connection that is being established.
Examples
# Specify the source IPv4 address of 192.168.20.222 for FTP packets sent to an IPv4 FTP server.
<Sysname> system-view
[Sysname] ftp client source ip 192.168.20.222
ftp client ipv6 source
to specify the source IPv4 address for FTP packets sent to an IPv4 FTP
to restore the default.
: Specifies an IPv4 address. For successful FTP packet transmission,
ftp
ftp client source
ftp ipv6
: Specifies an interface by its type and
command takes precedence over the source address
command.
ftp client source
command applies only to the FTP
ftp
102
command applies to all FTP
command applies only to the FTP
command applies to all FTP