Reset Version-Update-Record; Version Auto-Update Enable - HP Enterprise FlexFabric 12900E Series Command Reference Manual

Images stop running in memory immediately after they are deactivated. However, only patch images
deactivated by using the
after a reboot. To prevent other deactivated images from running after a reboot, you must commit the
software change by using the
Examples
# Deactivate the patch images in the route-patch.bin file on the specified slot.
<Sysname> install deactivate patch flash:/route-patch.bin slot 1
This operation might take several minutes, please wait...Done.
Related commands
display install active
display install inactive

reset version-update-record

Use
reset version-update-record
Syntax
reset version-update-record
Views
System view
Predefined user roles
network-admin
Examples
# Clear the startup software image upgrade records.
<Sysname> system-view
[Sysname] reset version-update-record
This command will delete all records of version update. Continue? [Y/N]:y
Related commands
display version-update-record

version auto-update enable

Use
version auto-update enable
standby MPU at startup.
Use
undo version auto-update enable
Syntax
version auto-update enable
undo version auto-update enable
Default
Software synchronization from active MPU to standby MPU is enabled. If software inconsistency is
detected at startup, the standby MPU loads the current software images of the active MPU.
Views
System view
install deactivate patch filename all
install commit
to clear startup software image upgrade records.
to enable software synchronization from active MPU to
194
command.
to disable this feature.
command do not run