Table of Contents
Advertisement
Chapter 4: Installing the Switch on a Table
104
Figure 46. Inserting the Rivet into the Bumper Foot
5. Repeat steps 2 to 4 to install the remaining bumper feet.
6. Turn the switch over and place it on a flat, secure desk or table,
leaving ample space around it for ventilation.
7. After installing the switches of the stack, do one of the following:
To build the stack with the default stacking ports, refer to Chapter
7, "Building the Trunk with the Default 10Gbps Stacking Ports" on
page 141.
To build a stack of GS980MX/10HSm, GS980MX/18HSm,
GS980MX/28PSm, or GS980MX/52PSm switches using 5Gbps
ports for the trunk, refer to Chapter 8, "Configuring the Master of
the Stack Trunk with 5Gbps Multi-Speed Ports" on page 161 and
Chapter 9, "Configuring the Member(s) of the Stack Trunk with
5Gbps Multi-Speed Ports" on page 199.
Advertisement
Table of Contents
