Allied Telesis AlliedWare Plus GS980MX Series Installation Manual page 175

Table 24. Verifying the Master GS980MX/10HSm Switch (Continued)
Step
3 Enter the SHOW STACK command. Here is an example of the display:
awplus# show stack
Virtual Chassis Stacking summary information
ID Pending ID
1 -
2 -
3 -
4 -
Operational Status
Stack MAC address
Check the display for the following:
- Switch ID 1 is the master switch.
- The master switch should have the priority 1. If it does not, repeat "Configuring the
Master GS980MX/10HSm Switch – Part I" on page 169. Be sure to perform the
STACK PRIORITY command and to save your changes with the WRITE command.
- The other ID entries are for the provisioned member switches. There should be one
entry for each member switch that will be in the stack. Their fields are empty because
the master switch is not yet part of a stack. If the table does not include these fields,
repeat "Configuring the Master GS980MX/10HSm Switch – Part II" on page 173. Be
sure to perform the SWITCH PROVISION command and to save your changes with
the WRITE command.
- The Operational Status should be Standalone Unit, indicating that stacking is
enabled, but that the unit is operating as a stack of one switch. If the status is
Stacking Hardware Disabled, the stacking feature is disabled. Repeat "Configuring
the Master GS980MX/10HSm Switch – Part I" on page 169. Be sure to perform the
STACK ENABLE command and to save your changes with the WRITE command.
Description and Command
MAC address
e01a.ba56.c208
-
-
-
GS980MX Series Installation Guide for Virtual Chassis Stacking
Priority Status
1 Ready
- -
- -
- -
Standalone unit
e01a.ba56.c208
Role
Active Master
Provisioned
Provisioned
Provisioned
175