Table of Contents
Advertisement
Chapter 7: Building the Trunk with the Default 10Gbps Stacking Ports
Adding Ports 49 and 50 on GS980MX/52 or GS980MX/52PSm
Switches to the Stack Trunk
Table 21. Adding Ports 49 and 50 to the Stack Trunk on the GS980MX/52 or GS980MX/52PSm
Step
1
Start a local management session on any switch in the stack. Refer to "Starting a
Local Management Session" on page 150.
2
Move to the Privileged Exec mode with the ENABLE command.
awplus> enable
3
Move to the Global Configuration mode with the CONFIGURE TERMINAL command.
awplus# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
4
Enter the port Interface mode for ports 49 and 50 on all the on the GS980MX/52 or
GS980MX/52PSm switches in the stack. This example assumes the stack has four
switches:
awplus(config)# interface port1.0.49-1.0.50,port2.0.49-
2.0.50,port3.0.49-3.0.50,port4.0.49-4.0.50
Designate the ports as stacking ports with the STACKPORT command.
5
awplus(config-if)# stackport
% Save the config and restart the system for this change to take
effect.
Return to the Global Configuration mode.
6
awplus(config-if)# exit
156
This procedure explains how to add ports 49 to 50 to the stack trunk on
the GS980MX/52 or GS980MX/52PSm switch. The procedure assumes
the following:
You performed the procedures earlier in this chapter to power on
and verify the stack with ports 51 and 52 as the stack trunk.
Ports 49 to 50 are not cabled. If there are cables connected to the
ports, remove them before performing the procedure.
To add ports 49 and 50 to the stack trunk, perform the following
procedure:
Switch
Description and Command
Advertisement
Table of Contents
