Table of Contents
Advertisement
Table 43. Configuring Member GS980MX/52PSm Switches – Part I (Continued)
Step
13
Check the ID LED on the front panel and do one of the following:
- If the ID LED is displaying the switch's new ID number, go to "Configuring Member
GS980MX/10HSm Switches – Part II," next.
- If the ID LED is displaying a different number, repeat this procedure. Be sure to
correctly enter the STACK RENUMBER command and to save your changes with the
WRITE command.
14
Go to "Configuring Member GS980MX/52PSm Switches – Part II" on page 223.
Configuring
Member
GS980MX/
52PSm Switches –
Part II
Table 44. Configuring Member GS980MX/52PSm Switches – Part II
Step
1
Start a new local management session on the member switch. Refer to "Starting a
Local Management Session" on page 150.
2
Enter the ENABLE command to move from the User Exec mode to the Privileged
Exec mode.
awplus> enable
Steps 3 and 4 set the switch's priority value to be the same as its ID number.
3
Move to the Global Configuration mode with the CONFIGURE TERMINAL command.
awplus# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
4
Assign a priority value to the switch equal to its ID number, with the STACK
PRIORITY. This example assigns priority 2 to a member switch with the ID 2:
awplus(config)# stack 2 priority 2
Steps 5 and 6 remove the stacking function from the default 10Gbps stacking ports on the
member switch.
Description and Command
This section contains instructions to the second part to configuring
member switches. The instructions explain how to configure the following
parameters:
Set the priority number. For background information, refer to
"Configuring the Member Switch" on page 201.
Designate the stacking ports for the stack trunk. Refer to "Stack
Trunks" on page 63.
To configure a member switch, perform the procedure in Table 44.
Description and Command
GS980MX Series Installation Guide for Virtual Chassis Stacking
223
Advertisement
Table of Contents
