Configuring Gs980Mx/18Hsm; Configuring The Master Gs980Mx/18Hsm Switch - Part I; Table 25: Configuring The Master Gs980Mx/18Hsm Switch For 5Gbps Stacking Ports - Part I - Allied Telesis AlliedWare Plus GS980MX Series Installation Manual

Configuring GS980MX/18HSm

Configuring the
Master
GS980MX/
18HSm Switch –
Part I
Table 25. Configuring the Master GS980MX/18HSm Switch for 5Gbps Stacking Ports – Part I
Step
1 Power on the master switch and wait two minutes for it to initialize the management
software. Refer to "Powering on the Stack" on page 228.
2 Start a local management session. Refer to "Starting a Local Management Session" on
page 150.
3 Move to the Privileged Exec mode with the ENABLE command.
awplus> enable
Steps 4 to 6 display the status of the switch hardware and the version number of the AlliedWare
Plus management software.
4 Verify that the switch hardware is operating correctly by entering the SHOW SYSTEM
ENVIRONMENT command. All components should have the status Ok.
awplus# show system environment
Environment Monitoring Status
Overall Status: Normal
Resource ID: 1 Name: GS980MX-18
ID Sensor (Units)
1 Fan: Fan 1 (RPM)
2 Voltage: 1.0V (Volts)
.
To configure the master GS980MX/18HSm switch to use 5Gbps ports for
the stack trunk, perform the procedure in Table 25.
Description and Command
Reading
5980
1.040
GS980MX Series Installation Guide for Virtual Chassis Stacking
Low Limit High Limit
4800
0.891 1.090
Status
- Ok
Ok
177