Allied Telesis AlliedWare Plus GS980MX Series Installation Manual page 216

Chapter 9: Configuring the Member(s) of the Stack Trunk with 5Gbps Multi-Speed Ports
Table 40. Configuring Member GS980MX/28PSm Switches – Part I (Continued)
Step
5 Move to the Global Configuration mode with the CONFIGURE TERMINAL command.
awplus# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Step 6 enables the VCStack feature on the switch. You will probably not need to perform the step
because the feature is enabled by default. If the Switch ID LED is displaying "0", perform the step.
Otherwise, go to step 7.
6 Activate VCStack on the switch with the STACK ENABLE command.
awplus(config)# stack enable
% Automatically enabling 'stack virtual-mac' to minimize disruption form
failovers.
% Please check that the new MAC 0000.cd37.0431 is unique within the
network.
% Save the config and restart the system for this change to take effect.
Steps 7 to 13 set the member switch's ID number, save your changes, and reboot the unit.
7 Set the ID number of the member switch with the STACK RENUMBER command. If you
are using the worksheet on Table 19 on page 85, refer there for the ID numbers. This
example assigns the ID number 2 to the member switch.
awplus(config)# stack 1 renumber 2
% Warning: the new ID will not become effective until the stack-member
reboots.
% Warning: the boot configuration may now be invalid.
8 Return to the Privileged Exec mode.
awplus(config)# exit
Enter the WRITE command to save your change. If this is the first management session,
9
the switch adds the configuration file DEFAULT.CFG to flash memory, for storing your
configuration changes.
awplus# write
Building configuration ...
[OK]
10 Restart the switch with the REBOOT command.
awplus# reboot
reboot system? (y/n):
awplus#
11 Type "Y" for yes.
12 Wait two minutes for the switch to initialize its management software.
216
Description and Command