Burst Trigger Mode - IAI GOX-5105M-PGE User Manual

GOX-5105MC-PGE | GOX-8105MC-PGE | GOX-12405MC-PGE | GOX-16205MC-PGE | GOX-20405MC-PGE | GOX-24505MC-PGE

Burst Trigger Mode

Related Setting Items:
In Burst Trigger mode, when a single external trigger signal is received, the camera acquires images
continuously at high speed, stores the images in the internal memory temporarily, and then the image
data is read out. Data readout is limited to GigE Vision's readout speed (up to 1 Gbps).
You can use BurstTrigger mode when:
Image Compression Mode (Xpress)
l
One or both of the following trigger modes is enabled:
l
ExposureMode is set to Timed, and FrameStartTrigger is set to On
l
TriggerMode[AcquisitionStart] = On
l
Note: If BurstTrigger[ExposureModeOption] is set to On from Off or RCT, GainAuto,
ExposureAuto and BalanceWhiteAuto will be forced Off.
Max Frame Rate for Burst Trigger Mode
The maximum frame rate value for BurstTrigger mode is the maximum frame memory write speed (up
to 6 Gbps) or the sensor maximum frame rate, whichever is slower.
Number of Frames That Can Be Acquired in Burst Trigger Mode
In BurstTrigger mode, all acquired frames cannot be output because the maximum frame rate for
BurstTrigger mode is higher than the GigE bandwidth frame rate. Therefore, the number of frames that
can be acquired in BurstTrigger mode is defined by the number of frames that can be stored in the
camera's internal memory.
AcquisitionControl
= Off
User Manual (Ver. Preliminary) - Main Functions
- 38 -