Blemishcontrol - IAI GOX-5105M-PGE User Manual

GOX-5105MC-PGE | GOX-8105MC-PGE | GOX-12405MC-PGE | GOX-16205MC-PGE | GOX-20405MC-PGE | GOX-24505MC-PGE

BlemishControl

Configure settings for JAI white blemish correction.
Related Topic: BlemishCompensation
Blemish Control Item
BlemishEnable
BlemishDetect
BlemishDetectionResult
BlemishDetectThreshold
BlemishStore
BlemishCompensationIndex
BlemishCompensation
PositionX
Setting Default
Range Value
Enable/disable blemish correction.
0: Disable all
- 1: Enable
1: Enable
2 :Disable user detection
Execute blemish detection. This command cannot be executed under the
following conditions.
- No image is being output.
- TestPattern is being output
- In Sequencer Mode
- -
- In MultiRoi mode
- The image is not full ROI size
- In Reverse mode
- GradationCompressionMode is not Off
- AcqusitionMode is not Continuous
- Not in lens cap state
Display the blemish detection results.
0: Idle
1: Succeeded
2: Error1 - image was too bright
- 0
3: Error2 - image was too dark (unused)
4: Error3 - signal level was unbalanced (unused)
5: Error4 - detect blemishes too many
6: Error5 - could not detected
7: Error6 - timeout
1～ 99 10 Set the blemish detection threshold.
Save the location information of detected blemishes, manually specified by
- -
BlemishiCompensationPositionX and BlemishCompensasionPositionY.
1～ 2000 1 Select the index for the target blemish coordinates.
Display the X coordinate (horizontal pixel position) of the target blemish
selected in BlemishCompensationIndex. You can also manually enter the X
coordinate of the blemish you want to correct.
- -1
Min: -1
Max: WidthMax - 1
User Manual (Ver. Preliminary) - Setting List
Description
(Sequencer Function)
(ROI Function (Multi
(ROI Function (Single
(Image Flip Function)
- 114 -
ROI))
ROI))
(Gradation Compression Mode)
(Acquisition Control)