Set Cut By Amount; D Set Dot Size Width And Height - Honeywell E-Class Series User Manual

141100001000100DATAMAX
Result
The sample above shifts all format data 0.5 inches to the right, unless the printer is in
metric mode (see Label Formatting Command
Limitations
If using preprinted labels where the placement of the preprint data varies from label
to label, the printed information may overlap the preprinted data.
c Set Cut by Amount
This command is the same as the ":" command, except only a two-digit value can be
entered. This command allows a predetermined number of labels to be printed before
a cut is initiated. 1 to 99 labels may be printed before a cut is made.
Syntax
cnn
Parameters
Where:
nn - Is a two-digit number indicating the number of labels to be printed before a cut
l
is performed. The default is one.
Sample
<STX>L<CR>
c07<CR>
141100001000100SAMPLE LABEL<CR>
Q0021<CR>
E
Result
The sample above instructs the printer to make cuts after labels 7, 14, and 21 have
been printed. See Label Formatting Command
Limitations
The cutter must be enabled and all mechanism interlocks closed for the cut operation.

D Set Dot Size Width and Height

This command is used to change the size of a printed dot, hence the print resolution -
dots per inch (DPI) of the print head. By changing the height of a dot, the maximum
DPL Command Reference
m Set Metric Mode).
: Set Cut by Amount.
132