Stx Ktu Read Unique Serial Number From Rfid Tag - Honeywell E-Class Series User Manual

Un1...n16 - (Optional) Where n1...n16 is the Unique Identifier (UID) in hexadecimal
l
format. Must be sixteen characters long.
H - (Optional) Hexadecimal data – "H" may be added directly after "R" to return a
l
two character hex value of the data. Since there are two digits per hex value, replace-
able fields should be twice as long than if using ASCII data (e.g., the character "A"
would be returned as "41").
aaa - Starting block number (000 - maximum block number). Transponder depend-
l
ent.
bbb - The number of blocks to read (001 - maximum block number). Transponder
l
dependent.
c - The number of retry attempts, 0-9.
l
d - Reserved. Should be 0.
l
ee - Field number in which to place the data (must be 01, 02, 03, etc.) matching the
l
order of Label Formatting command, U. A 00 value will send tag data to the host
with no printing.
Sample
<STX>L
1911A1802000010TEXT
U
X
<STX>KtRUE00700ABCDEF1234H0000015001
<STX>G
Result
The sample creates a replaceable text field (01), recalls data from the RFID tag block
zero (reading only one block, which is attempted nine times), and prints the data in
the location specified by replaceable field.
Note: When using addressed commands and the tag with the specified UID cannot be
found, a standard RFID read/write fault will be issued.

STX KtU Read Unique Serial Number from RFID Tag

Direct Mode – HF [13.56 MHz] ISO15693 Tag Interface
This command instructs the RFID device to read the unique serial number data from
the tag and then place that data into a replaceable field. It is expected that the tag
transponder will be within the read / write distance of the RFID programming device;
otherwise, "Void" will be printed in the text or barcode label field(s).
This is a sixteen character alphanumeric value; the replaceable field must have an
adequate length.
Syntax
<STX>KtUabcc<CR>
DPL Command Reference
60