He Heat; Ht Host Timeout; Ic Ignore Control Codes - Honeywell E-Class Series User Manual

number specified is exceeded three times, the printer will fault until cleaning is
initiated.
Parameter:
Value / Range:
Units / Interpretation:
Command Equivalent:

HE Heat

See Hnn for command details.
Parameter:
Value / Range:
Units / Interpretation:
Command Equivalent:

HT Host Timeout

This command controls the number of seconds a communications port must be idle
before the printer will process data from a different port or use a different parsing
method. The value is also used to "timeout" an image / label format download (i.e., if,
at any time, data flow stops before a complete label format is received, the data will be
ignored).
Parameter
Value / Range:
Units / Interpretation:
Command Equivalent:

IC Ignore Control Codes

This command allows the user to remove control codes (< 20 Hex) in the data field.
The selected line terminator is processed. When enabled, DPL Control Code (SOH,
STX, CR, ESC, and ^) characters are removed from the data string. (Note that some
fonts do have printable characters in this range and they will not be printed when
enabled.)
Parameter:
Value / Range:
Units / Interpretation:
Command Equivalent:
92
HC
0 - 9999; 0 disables this function
Inches (or centimeters) multiplied by 1000
N/A
HE
0 – 30
N/A
Hnn
HT
1 - 60
Seconds
N/A
IC
Y, N or 1, 0
Y = Enabled, N = Disabled; or 1 = Enabled, 0 = Disabled
N/A
DPL Command Reference