Table of Contents
Advertisement
Pin
Signal
Number
Name
Ribbon
9
Low
Service
10
Required
End Of
11
Print
12
Media Out
Ribbon
13
Out
Data
14
Ready
Option
15
Fault
[1] Signal directions are given relative to the printer.
[2] If active with no current print job, "WAITING FOR DATA" will be displayed.
Specifying a quantity of 9999 while keeping this signal "On" will cause non-stop label
printing, except in single label "Imaging Mode", which will cause the printer to stop
between labels
260
Signal
Direction
Jumper
[1]
Output
JMP 1
Position
Programmable [1]. Signifies a
When inactive,
RIBBON LOW DIAMETER warning.
outputs will be
Evoked by occurrences listed under
pulled up to a
"Fault Messages"[1]. Active LOW.
voltage determined
by this jumper
Programmable [1]. Signifies the End
setting, where:
of Print (EOP) process.
Evoked during an Out of Stock
Pins 1 – 2 =
condition. Active LOW.
+5VDC;
Evoked during an Out of Ribbon
Pins 2 – 3 =
condition. Active LOW.
+24VDC; or,
Evoked when a label is waiting to be
None = A common
printed. Then after the printer
external voltage
receives the Start of Print signal,
(not to exceed
printing will begin. For
+30VDC) via
synchronization with the print cycle,
external pull-ups
the End Of Print signal indicates
(providing a 20K
the completion of the print process.
ohm feedback path
Active LOW.
through any two
Evoked during a Linear Scanner or
outputs).
RFID fault condition. Active LOW.
Function / Description
DPL Command Reference
Advertisement
Table of Contents
