Table of Contents
Advertisement
1.888.610.7664
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
Waveform Size
You can select "Small", "Medium", or "Large" as the waveform display mode.
Offset
Offset is used to set the vertical offset of the operation result. You can set the vertical
offset in the following ways.
•
In Math menu, rotate the corresponding multipurpose knob on the front panel
or click or tap the icon at the right side of the input field of Offset to increase or
decrease the scale value. You can also click or tap the input field to input a
specific value with the displayed numeric keypad.
•
Close the menu and then adjust the vertical offset with the drag gesture on the
touch screen. You can also rotate the corresponding multipurpose knob on the
front panel to adjust the vertical offset. Please refer to
configure the front-panel multipurpose knobs.
Sensitivity
Sets the sensitivity of the digital signal converted from the analog signal on the
source. Click or tap the Sensitivity input field to set the sensitivity with the pop-up
numeric keypad or use the corresponding multipurpose knob to set the value. For
Parameter Setting Method
details, refer to
Waveform
This oscilloscope provides Main and Zoom for the measurement range.
•
Main indicates that the measurement range is within the main time base region.
•
Zoom indicates that the measurement range is within the zoomed time base
region.
To use "Zoom", first enable the
System
menu.
Threshold
Click or tap the threshold input field of the specified channel and use the pop-up
numeric keypad to set the threshold or use the corresponding multipurpose knob to
set the value.
www.calcert.com
15
10
20
5
25
0
30
.
Zoom Mode (Delayed Sweep)
Math Operation
Front Panel Overview
to
in the
Horizontal
sales@calcert.com
DHO1000 User Guide
Advertisement
Table of Contents
