Table of Contents
Advertisement
Measurements
1.888.610.7664
DHO1000 User Guide
-
Cursor A is a vertical solid line (
and Cursor B is a vertical dotted line (
screen).
-
In the XY cursor mode, X cursor is used to measure the waveform
amplitude of Source X.
•
Y Cursor
Y cursor is a horizontal solid/dotted line that is used to make vertical
adjustments. It can be used to measure amplitude (the unit is the same as that of
the source channel amplitude).
-
Cursor A is a horizontal solid line (
the screen), and Cursor B is a horizontal dotted line (
right section of the screen).
-
In XY cursor mode, Y cursor is used to measure the waveform amplitude of
Source Y.
You can enable cursor measurements in the following ways.
•
Click or tap the function navigation icon
measurements.
•
Click or tap the Cursors button on the toolbar to enable cursor measurements.
•
Press the front-panel
The measurement results are displayed in the "Result" bar at the right side of the
screen.
•
AX: indicates the X value at Cursor A.
•
AY: indicates the Y value at Cursor A.
•
BX: indicates the X value at Cursor B.
www.calcert.com
15
10
20
5
25
0
30
is displayed at the bottom of the screen),
is displayed at the bottom of the
is displayed at the right section of
> Cursors to enable cursor
key to enable cursor measurements.
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
is displayed at the
sales@calcert.com
Advertisement
Table of Contents
