Table of Contents
Advertisement
1.888.610.7664
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
Figure 10.14 XY Mode Setting Menu
TIP
By default, XY mode is unavailable. It is available only when the horizontal time base mode is
"XY". To enable the XY mode, please refer to
Adjust Cursor Position
•
Click or tap to select the "X" tab under the Select menu item to set the X value
for the specified cursor.
-
Click or tap the input field of AX and use the pop-up numeric keypad to set
the X value at Cursor A.
-
Click or tap the input field of BX and use the pop-up numeric keypad to set
the X value at Cursor B.
-
Click or tap the AX BX on/off switch to turn on/off adjusting the X value at
Cursor A and the X value at Cursor B simultaneously.
•
Click or tap to select "Y" under the Select item to set the Y value for the
specified cursor.
-
Click or tap the input field of AY and use the pop-up numeric keypad to set
the Y value at Cursor A.
-
Click or tap the input field of BY and use the pop-up numeric keypad to set
the Y value at Cursor B.
-
Click or tap to the AY BY on/off switch to turn on/off adjusting the Y value
at Cursor A and the Y value at Cursor B simultaneously.
You can also use the front-panel multipurpose knob
position. To configure the multipurpose knobs, please refer to
During the adjustment, the measurement results will change accordingly. The
adjustable range is limited within the screen.
www.calcert.com
15
10
20
5
25
0
30
Enable the XY Mode
.
to adjust the cursor
Front Panel Overview
sales@calcert.com
Measurements
.
DHO1000 User Guide
Advertisement
Table of Contents
