Table of Contents
Advertisement
1.888.610.7664
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
•
Remote ID: triggers on the specified ID of Remote frame. When you select
Remote ID, you need to set the following parameters.
-
Click or tap the Extended ID on/off switch to enable or disable the
extended ID.
-
Click or tap the input field of ID, and then the "Format" interface is
displayed. You can set the ID that needs to be operated on. For details, refer
to descriptions in
•
Overload: triggers on the overload frames.
•
Frame ID: triggers on the data frames with the specified ID. After you select
Frame ID, you can refer to the "Remote ID" mentioned above to set the
Extended ID and ID.
•
Frame Data: triggers on the data frames with the specified Data. When you
select Frame Data, you need to set the following parameters.
-
Click or tap the input field of Data, and then the "Format" interface is
displayed. You can set the data bit that needs to be operated on. For
details, refer to descriptions in
-
Click or tap the input field of Bytes, and then use the pop-up numeric
keypad to set the length of the data. You can also use the corresponding
multipurpose knob to set the value. Its range is from 1 to 8.
•
Data & ID: triggers on the data frames with the specified ID and data. When you
select Data & ID, you need to set the ID, Extended ID, Data, and Bytes.
•
Frame Error: triggers on the error frame.
•
Bit Fill: triggers on the error frame with the bit fill.
•
Answer Error: triggers on the answer error frame.
•
Check Error: triggers on the check error frame.
•
Format Error: triggers on the format error frame.
•
Random Error: triggers on the random error frame, such as the format error
frame, answer error frame, etc.
Trigger Mode
In Sweep, select Auto, Normal, or Single as the trigger mode. For details, refer to
descriptions in
Trigger Mode
Trigger Parameter Setting
You can refer to
Noise Rejection
www.calcert.com
15
10
20
5
25
0
30
I2C Trigger
.
I2C Trigger
.
.
to set the noise rejection under this trigger type.
Triggering the Oscilloscope
sales@calcert.com
DHO1000 User Guide
Advertisement
Table of Contents
