Table of Contents
Advertisement
9. Take out the filament box and extruder module accessory box.
10. Please remove the two clips from both sides of the belt before using.
Hardware Installation
Print Bed Installation
Tear off the tape affixed to the backside of the Rubber Magnet (Accessory 10) and then align the
magnet with the corner of the print bed. Next, press the magnet down until it is attached to the
print bed securely.
After that, load the Removable metal print bed (Accessory 11) on the magnetic-bonded print
bed.
Extruder Module Installation
Hand Tools: L shaped torx Key(accessory 16) or T10 Torx Screwdriver.
Disconnect the power. Insert the heated flat cable and then align the extruder module with the
correct position of the 3-point screw hole. After that, tighten these 3 screws with the L-shaped
torx key (Accessory 16) respectively until the extruder module is secured in position.
Mind the pinching position (as shown in the figure) when
inserting the heating cable into the interface, and confirm the
fool-proof position, then align the two ends and insert with
even force.
9
Advertisement
Table of Contents
