Installation - XYZ Printing da Vinci Pro EVO User Manual

Extruder Module Removement

Filament should be unloaded from the extruder module before module removement.
Loosen the screws at the three holes (loosening instead of taking down the screws, and keep the
screws on the holes), support the extruder module by hand, then press both ends of the heating
cable to pull it out.
Guide Tube and Clear Tube Installation

Insert one end of the guide tube (accessory 8) into the feed module and secure it tightly.
Insert the clear tube (accessory 9) into another end and be sure to complete this installation, in
order to press the clear tube down to remove the guide tube in the future. (Please be sure to
complete this step to facilitate pressing down the clear tube and removing the guide tube)
Press the filament guide tube goes into the feed hole of the extruder module tightly and the
installation of the filament guide tube is duly completed.
Guide tube clips (This file is stored on USB drive) and Top cover buckle


Installation

Guide tube clips (accessory 15) is used to fix the wires and guide tube, and can stabilize when
moving of the wires and tube during printing.
Please avoid the distance position that will touch the upper cover when the printing moves.
Mind the pinching position (as shown
in the figure), and pull out the heating
cable with even force.
10