Table of Contents
Advertisement
4-3.
Clean Nozzle
Be sure to unloaded the filament and unplug the guide tube before cleaning the nozzle.
The print bed will move down when cleaning the nozzle, and the extruder module will
move to the cleaning position.
Start cleaning the nozzle after it is heated up to the working temperature.
Or adjust the heating temperature according to the filament used, and wait for the print
head to be heated to the cleaning temperature before cleaning.
General printing module temperature range: 190-260℃
High temperature printing module temperature range: 250-300℃
*
For the operation of Clean Nozzle, please refer to 3-2. Print Head.
5.
Dynamic Adjust
The setup function will appear under the Printing status.
During the printing process, you may fine-tune the required parameters such as "Print
Bed", "Extruder Module", and "Fan". These parameters can be adjusted according to the
printing status to improve the printing quality.
30
Advertisement
Table of Contents
