XYZ Printing da Vinci Pro EVO User Manual page 39

Federal Communications Commission (FCC) Statement
You are cautioned that changes or modifications not expressly approved by the part responsible for
compliance could void the user's
authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC rules. These
limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and receiver.
● Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
● Consult the dealer or an experienced radio/TV technician for help.
XYZprinting is not responsible for any radio or television interference caused by using other than
recommended cables and connectors
or by unauthorized changes or modifications to this equipment. Unauthorized changes or modifications
could void the user's authority to
operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
this device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
This device complies with FCC radiation exposure limits set forth for an uncontrolled environment and it
also complies with Part 15 of the
FCC RF Rules. This equipment must be installed and operated in accordance with provided instructions and
the antenna(s) used for this
transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must
not be co-located or operating
in conjunction with any other antenna or transmitter. End-users and installers must be provided with
antenna installation instructions and
consider removing the no-collocation statement.
www.xyzprinting.com
39