Note On Power Supply - XYZ Printing da Vinci Pro EVO User Manual

Do not place the printer in a dusty, humid or outdoor environment.

Weak odors may be generated during the printing process. We recommend working in a

well-ventilated.
Do not leave the product or power cord to unattended children. Otherwise, personal injury

or electric shock might occur.
Do not place any liquid container on top of the product. Otherwise, overflow or spill might

go into the machine and pose the risks of danger or safety concern.
Do not wipe the printer with alcohol or flammable chemicals. Otherwise, danger might

occur.
Do not move the machine when it's powered on.

Please use the provided power cord. Otherwise, incorrect grounding might lead to

damage.
Do not reach into the machine with your hands during operation. Otherwise, risks of

impact from moving printing parts or burn from high temperature might occur.
The machine becomes hot during operation and thus run in high temperature. Do not

touch or replace parts when they are not cooled down.
After startup, the parts in the machine will heat up or move depending on the user's

instructions. During product operation, do not touch or block the operation of the parts.
Defect reparation must be carried out according to the contents of this instruction manual.

Where the defect cannot be repaired, please contact your printer dealer or the customer
service center.

Note on Power Supply

Do not use with damaged cord or plug. To unplug grasp the plug, not the cord. Do not

handle plug or machine with wet hands.
Do not handle plug or machine with wet hands. Turn off the power switch before

unplugging.
Do not run the machine over cord. Keep cord away from heated surfaces.

If the system is left in idle mode for an extended amount of time, turn off the main switch.

Safety Notice and label
Warning
Class I Equipment. This equipment must be earthed. The power plug must be connected to a properly wired
earth ground socket outlet. An improperly wired socket outlet could place hazardous voltages on accessible
metal parts.
Marking of hazardous moving parts
3