XYZ Printing da Vinci Pro EVO User Manual page 27

3-9. Advanced
(1) Axis Step Calibration
Enter this page to display the current values of X, Y, Z and E axes. Users may make
advanced adjustment of X, Y, Z and E axis values under non printing state to correct
inaccurate moving distances.
E axis is the advancing distance of the jogging filament of the feed module.
Definition: the number of steps required to move 1mm.
For example: when the X/Y axis moves 100mm, if it actually moves 100.5mm, the
adjustment value should be 79.6.
Or if it actually moves 99.5mm, the adjustment value should be 80.4.
The preset values are listed in the figure showed upper right.
(2) Safety Sensor
The front cover detection system is set On by default. When the front cover is opened
during printing, printing will stop and a reminder message will appear.
Directly click the button to set it On or Off.
(3) Dry Filament
Please install the upper cover and the left and right sides first, then place a baking sheet
/ common photocopy paper on the bed, put the filament to be dried, and close the front
cover.
The print bed will be heated to 80°C during filament baking. The preset baking time is 16
hours. Users may adjust the time upward in 1 hour to the maximum of 48 hours, and
press "Done" at any time during the countdown to cancel / end the work.
* The filament reel box can be baked only after it can resist the temperature of 80°C.
* When taking out the wire, it is recommended to wear gloves when taking out the
filament to avoid burns due to high temperature.
27