Maintaining Transceivers And Fiber-Optic Cables On The Ptx10003-80C; Removing A Transceiver From The Ptx10003-80C - Juniper PTX10003-80C Hardware Manual

Maintaining Transceivers and Fiber-Optic Cables on
the PTX10003-80C
IN THIS SECTION

Removing a Transceiver from the PTX10003-80C | 143

Installing a Transceiver in the PTX10003-80C | 146
Disconnecting a Fiber-Optic Cable from a PTX10003-80C | 148
Connecting a Fiber-Optic Cable to a PTX10003-80C | 149
Maintaining Fiber-Optic Cables | 150
Removing a Transceiver from the PTX10003-80C
The transceivers for Juniper Networks devices are hot-removable and hot-insertable field-replaceable
units (FRUs). You can remove and replace them without powering off the device or disrupting device
functions.
NOTE: After you remove a transceiver or when you change the media-type configuration, wait for
6 seconds for the interface to display the operational commands.
Before you begin removing a transceiver from a device, ensure that you have taken the necessary
precautions for safe handling of lasers (see
Ensure that you have the following parts and tools available:
An antistatic bag or an antistatic mat
Rubber safety caps to cover the transceiver and fiber-optic cable connector
A dust cover to cover the port
Figure 61 on page 145 shows a QSFP+ transceiver.
"Laser and LED Safety Guidelines and Warnings" on page
143
190).