Air Techniques ScanX Swift View Installation And Operating Instructions Manual page 52

Troubleshooting
EN-
Error
US
Error code -10015
Error code 10017
Error code 2
Error code 78
Firmware not running
Settings (e.g. language) reset
after unit restart
Warning message during
shutdown of the unit
48
Possible cause
PSP fed in off-center
Unit shuts down
System error during startup of
the unit
Memory card full
Fault during memory cleanup
A firmware update has been car-
ried out
Internal communication fault
Faulty configuration file
Not a malfunction
Remedy
Insert the PSP centrally.
❯
Wait until the unit has shut
❯
down completely
Switch the unit off and back
❯
on again.
Update the firmware.
❯
Transmit image data to the
❯
computer.
Insert an empty memory card.
❯
Press and hold the reset but-
❯
ton while switching on the
unit.
Update firmware.
❯
Press and hold the reset but-
❯
ton while switching on the
unit.
Switch the unit off and on
❯
again.
Switch the unit off and on
❯
again.
Update the firmware.
❯
Reset the configuration to the
❯
factory settings and reconfig-
ure.
Update the firmware.
❯
2142100008L41 2202V007