Air Techniques ScanX Swift View Installation And Operating Instructions Manual page 27

Entering a permanent IP address (recom-
mended)
To reset the network settings, keep the
unit reset button pressed for 15 - 20 sec-
onds while switching on.
Deactivate DHCP.
❯
Enter the IP address, subnet mask and gate-
❯
way.
Click on Apply.
❯
This saves the configuration.
Testing the device
You can scan an X-ray image to check if the unit
is properly connected.
Select the Test tab.
❯
Select the unit from the Registered Devices
❯
selection list.
Select the mode class.
❯
Select the mode.
❯
Click on Scan Image.
❯
For the scanning of an image plate, see "11
❯
Operation".
2142100008L41 2202V007
Installation
EN-
US
23