Air Techniques ScanX Swift View Installation And Operating Instructions Manual page 10

Important information
EN-
Never touch the patient and unshielded plug
❯
connections of the device at the same time.
US
Replace any damaged cables or plugs immedi-
❯
ately.
Comply with the EMC rules concerning medi-
cal devices
The device is designed for use in a basic electro-
magnetic environment in accordance with
IEC 61326‑1.
NOTICE
Negative effects on the EMC due to
non-authorized accessories
Use only Air Techniques accessories or
❯
accessories approved by Air Techni-
ques.
Using any other accessories may result
❯
in increased electromagnetic interfer-
ence emissions or the unit having
reduced electromagnetic immunity,
leading to an erroneous operation
mode.
NOTICE
Erroneous operation mode due to use
immediately adjacent to other devices
or with other stacked devices
Do not stack the unit together with
❯
other devices.
If this is unavoidable, the unit and other
❯
devices should be monitored in order
to ensure that they are working cor-
rectly.
2.6 FCC note
This device has been tested and complies with
the limits for a class B digital device as set out in
part 15 of the FCC regulations. These limits are
designed to provide adequate protection against
harmful interference in residential environments.
This device generates, uses, and can emit high-
frequency energy, and it can cause harmful inter-
ference to wireless communication systems if it is
not installed and used in accordance with the
instructions. However, this statement does not
offer a guarantee that no interference will occur in
a certain installation. If this device causes harmful
interference to radio or TV reception (this can be
tested by switching the device off and back on
again), users are recommended to attempt to
6
eliminate the interference by taking one or more
of the following measures:
Realign or reposition the reception aerial.
❯
Increase the distance between the device and
❯
the receiver.
To meet FCC requirements on HF exposure
❯
compliance, a safety distance of at least 20 cm
must be maintained between the device's inter-
nal aerial and all persons.
Connect the device to a power outlet on a dif-
❯
ferent circuit to the one the receiver is con-
nected to.
Consult a dealer or experienced radio/TV tech-
❯
nician.
2.7 Notification requirement of
serious incidents
The operator/patient has to report any serious
incident related the product to the manufacturer
and the competent authority of the Member
State, in which the operator and/or patient is
established/resident.
2.8 Only use genuine parts
Only use accessories and optional items speci-
❯
fied or approved by Air Techniques.
Only use original working parts and spare
❯
parts.
Air Techniques accepts no liability for
damage resulting from the use of non-
approved accessories, optional items or
any parts other than original spare and
wear parts.
The use of non-approved accessories,
optional items or non-genuine wear
parts / replacement parts (e. g. mains
cable) can adversely affect the electrical
safety and EMC.
2.9 Transport
Only the original packaging ensures optimum
protection for the unit during transport.
If necessary, the original packaging for this unit
can be ordered from Air Techniques.
Air Techniques cannot be held responsi-
ble for any damage resulting from trans-
port in unsuitable packaging, even during
the warranty period.
Only transport the unit in its original packaging.
❯
2142100008L41 2202V007