Air Techniques ScanX Swift View Installation And Operating Instructions Manual page 25

8 Commissioning and first
start-up
NOTICE
Short circuit due to the build-up of
condensation
Do not switch on the unit until it has
❯
warmed up to room temperature and
is dry.
The unit supports the following imaging pro-
grams:
– VisionX manufactured for Air Techniques
– DBSWIN manufactured for Air Techniques
– Please inquire about third-party software
Always use the current version of the
imaging program in the commissioning of
the device. Check the version of the
enclosed imaging program versus the ver-
sions available at www.airtechni-
ques.com.
8.1 Configuring the network
Switch on the network devices (router, PC,
❯
switch).
Check if TCP port 2006 and UDP port 514 are
❯
enabled in the firewall; enable them, if neces-
sary.
If you are using the Windows firewall, you do
not need to check the ports since you will be
asked whether you want to enable them during
the driver installation process.
Network configuration
Various options are available for network configu-
ration:
ü Automatic configuration via DHCP.
ü Automatic configuration via Auto-IP for direct
connection of device and computer.
ü Manual configuration.
Configure the network settings of the device
❯
using the software or, if applicable, the touch
screen.
Check the firewall and release the ports, if
❯
applicable.
Network protocols and ports
Port Purpose
45123 UDP, Device recognition and
45124 UDP configuration
2142100008L41 2202V007
Port
2006 TCP
1)
514 UDP
The port can vary depending on the con-
1)
figuration.
Configuring WLAN on the unit
If the unit is to be operated via WLAN, the
enclosed WLAN stick must be inserted into the
USB connection on the back of the unit (see
"Connections"). The connection to the unit then
needs to be configured.
Proper functioning is only ensured if the
WiFi stick supplied by Air Techniques is
used.
In order to establish a secure WiFi con-
nection, we recommend encrypting the
WiFi network with WPA2.
The quality and transmission range of the
WiFi connection can be reduced by envi-
ronmental conditions (e.g. thick walls,
other WiFi devices). Mind the signal
strength when you select a suitable loca-
tion for set-up.
Requirements:
ü You need to be logged-in on the unit as
Administrator or Service Technician (Settings >
Access Levels > Administrator/Service Tech-
nician).
Check the WiFi settings with you Network
❯
Administrator.
Tap the following on the touch screen: Settings
❯
> System Settings > Network.
Under Interface, select the WLAN option and
❯
confirm with OK.
Configure the WLAN.
❯
Confirm with OK.
❯
When the unit is first connected to a com-
puter, it applies the language and time
settings of the computer.
8.2 Configuring the unit in
VisionX
Configuration is performed directly in VisionX.
Service
> Select the units.
❯
Installation
Purpose
Device data
Event protocol data
EN-
Service
US
Syslog
21