Table of Contents
Advertisement
Setting of setpoint values: setpoint value units
Parameter
Setpoint value 01
unit to
Setpoint value 30
unit
5.8.3
Analog variables
These settings affect the use of the analog variables (analog PLC outputs) for functions that have been
implemented in the device firmware (e.g. data recording).
Parameter
Name
Unit
Display start
Display end
5.8.4
Digital variables
These settings affect the use of the digital variables (digital PLC outputs) for functions that have been
implemented in the device firmware (e.g. data recording).
Parameter
Name
5.9
PLC parameters
The configuration structures that were individually created using the CPV Editor (CPVE) are displayed
here.
This configuration data can be used in the setup program, in the web application, and in the CODESYS
application.
NOTE!
The CPV Editor requires specific knowledge and is intended for use by the manufacturer only (service
that is subject to a fee).
Selection/data input
No unit
Absolute temperature
Relative temperature
Relative humidity
Ratio
Hours
Minutes
Seconds
Selection/data input
Enter text (or use existing text) Name of the variable concerned
Select signal type and unit
from the list (drop-down menu)
-99999 to 99999
(0)
-99999 to 99999
(100)
Selection/data input
Enter text (or use existing text) Name of the variable concerned
5 Configuration
Description
Unit of the setpoint value concerned
Temperature value
Temperature difference
Relative humidity
Ratio of two values A and B (A / B) in percent
Hours
Minutes
Seconds
Description
Signal type and unit of the variable concerned
Lower limit of display range
Upper limit of display range
Description
81
Advertisement
Table of Contents
