Table of Contents
Advertisement
4
Operation
4.1
General information
The following options are available to operate the device:
•
Operation on the device
•
Use of the setup program
•
Use of the "JUMO Web Cockpit" web application using a web browser
The various options for operating the device differ in terms of the scope of the functions they support.
IP address
In order to access the device using the setup program or a web browser, the IP address of the device is
required. The IP address of the Ethernet interface concerned can be found using the device menu (De-
vice info > Ethernet > LANx). A user does not need to be logged on to do this (dependent on rights).
The Ethernet settings may need to be changed beforehand using the device menu (Configuration >
Ethernet > LANx). A user will need to be logged on to do this (dependent on rights).
The default setting is that DHCP is active.
User log-on
Please use the following details to log on for startup purposes:
•
User name: Master
•
Password: 9200
The password should be changed by the end of startup at the latest.
The password must be entered again each time the user logs on.
Hardware configuration
In order to start up a system (which comprises the device (CPU) and other system components (mod-
ules)), the system's hardware configuration needs to be created using the setup program. This cannot
be done using the device menu or the web application.
If the hardware is incorrectly configured, a bus error will be displayed.
Startup
Procedure during startup:
chapter 6 "Startup", Page 95
Device-specific information in this chapter
All the information in this chapter that refers to the JUMO variTRON 500 (705002) device also applies in
principle to the JUMO variTRON 300 (705003) device. Differences between the devices will be men-
tioned at the relevant points if necessary for the use of this manual. Device-specific sections or subchap-
ters are also used where required.
4 Operation
31
Advertisement
Table of Contents
