Table of Contents
Advertisement
4 Operation
chapter 5 "Configuration", Page 69
NOTE!
The settings configured under "Bus > Master" influence the transfer of data via the system bus. Sub-
optimal settings here will disrupt or even interrupt the communication within the system. For this reason,
these parameters are only permitted to be modified by a service engineer from the device manufacturer
(or by someone acting on their instructions).
The process of configuring the modules (controller, relay, analog IO units, digital IO units) is described
in the operating manual for the respective module.
chapter 1.8 "Available technical documentation", Page 18
47
Advertisement
Table of Contents
