Table of Contents
Advertisement
4 Operation
PLC application
If applicable, information from the PLC application is displayed here (PLC library "CmpDeviceInfo").
License management
Extra codes and their status are displayed here (active = extra code is active and can be used).
Real-time processing
Information on the relevant function (e.g. data recording) is displayed here (thread runtime, cycle count-
er, time-out counter, wakeup deviation).
Datastore gateway
Information about data recording is displayed here (version, export status of recorded data, database fill
level).
Cloud gateway
Information about the cloud gateway is displayed here (status, version).
Wtrans gateway (only for variTRON 300)
Information about the Wtrans gateway is displayed here (version, radio frequency; Wtrans transmitters:
e.g. transmitter ID, battery status, RSSI value; measured value, transmission interval).
4.4.2
Events
Event messages are extracted from the device and listed in chronological order here.
The information shown can be filtered by message type (alarm, audit trail, malfunction, event). It is also
possible to search for specific keywords and run a full-text search.
The "Refresh" function (button) refreshes the list.
The "Delete" function (button) deletes all entries from the list in the device.
NOTE!
The different types of event messages are organized in a common ring buffer. In the event that old en-
tries are overwritten, it is usually ensured that audit trail messages remain stored for at least 14 days.
4.4.3
Alarms
Alarm messages are extracted from the device and listed in chronological order here.
The information shown can be filtered by message type (alarm, malfunction). It is also possible to search
for specific keywords and run a full-text search.
The "Refresh" function (button) refreshes the list.
The "Confirm" function (button) acknowledges an alarm. For this purpose, the relevant alarm must be
selected (ticked) beforehand.
62
Advertisement
Table of Contents
