Table of Contents
Advertisement
4.2.2
Device menu
To access the device menu from the start screen, press the "Menu/OK" key.
The following overview shows the menu levels where individual functions can be configured (by selecting
or entering data) or information is shown. The information that is shown on the device display depends
on the user's rights.
Beyond this, there are functions that can only be configured with the setup program or the web applica-
tion; these functions are not listed here.
If you need further information on the individual functions, please see the subsequent chapters in this
manual (see cross-references).
User management
Sub-menu 1
Logon (log in)
Logoff (log out)
chapter 4.2.3 "User log-on", Page 35
System status
Sub-menu 1
Change the system status
Selection options: Run, Stop, Re-
set, Reset (Cold), Reset (Origin),
Reboot system
chapter 4.4.1 "Device information", Page 61
Configuration
Sub-menu 1
Device manager
Ethernet
Sub-menu 2
User (to be selected), password
(to be entered)
---
Sub-menu 2
---
Sub-menu 2
Device settings
Device designations
Time zone/NTP
LAN1
LANx
4 Operation
Sub-menu 3
---
---
Sub-menu 3
---
Sub-menu 3
Device language (selection)
Start-up behavior (selection op-
tions: Run, Stop, Last status)
Device name (display)
DNS name (display)
Time zone (selection)
NTP active (selection)
NTP server (display)
Max. round-trip time (to be en-
tered)
Method (selection options: Man-
ual, Automatic)
IP address (to be entered)
Subnet mask (to be entered)
Standard gateway (to be en-
tered)
Obtain DNS server IP (selection
options: False, True)
DNS server (entry of IP address)
see LAN1
33
Advertisement
Table of Contents
