Batches; Note - JUMO variTRON 300 Operating Manual

5 Configuration
5.17

Batches

Batch logging is configured here (available as of system version 6).
The batch data is displayed together with the channels of the assigned groups and the event messages
in the batch visualizations (evaluation with JUMO smartWARE Evaluation).
The maximum number of batches that can be recorded depends on the device (variTRON 300: 10 batch-
es; variTRON 500: 20 batches). However, the number of licensed batches is decisive for the evaluation
of the recorded batches (fee-based licenses for JUMO smartWARE Evaluation).

NOTE!

If no group has been assigned to the batch (or none of the assigned groups is active), only event mes-
sages are recorded.
NOTE!
With the variTRON 300, the user must ensure that the maximum number of 10 batches is not exceeded.
If the maximum number of batches is exceeded during configuration, this will result in the batch in ques-
tion not being recorded. In case of configuration with the Web Cockpit, a fault message is immediately
entered into the event list.
NOTE!
The configuration must not be changed during an ongoing batch reporting process. Otherwise, there is
a risk that the batch documentation will become unusable.
General information
Parameter
Batch active
Batch application
(batch name)
Control signal
Response to
power interrup-
tion (behavior af-
ter power
interruption)
Group allocation
Batch lines
For each batch, up to 10 lines can be defined for the batch report.
Parameter
ID
Text left column
92
Selection/data input
Off (FALSE)
On (TRUE)
Enter text (or use existing text) Assignment or designation of the batch
Select signal from selector
Continuation
Abort
Select group from selector
Selection/data input
Enter text (or use existing text) Designation (ID) of the relevant line of the batch re-
Enter text (or use existing text) Text in the left column of the batch report.
Description
Batch reporting is not active.
Batch reporting is active and can be started.
Signal that is used to start (high active) and stop
batch reporting.
Batch reporting is continued.
Batch reporting is stopped.
The batch is completed with the last recorded data
(before the power failure).
Group that is assigned to the batch.
All groups can be assigned to one batch.
Description
port (e.g. for use in the PLC application)
The identifier must be unique within a batch.
The left column contains the designation for the
content of the right column.