Table of Contents
Advertisement
5 Configuration
Parameter
End of display
range
Unit
(only with system
version 6)
Replace display
parameters
As of system version 7:
Scaling type
Digital channels
Parameter
Input signal
As of system version 6:
Designation
Replace designa-
tion
Standard operation
Parameter
Memory status
Memory rate
[hh:mm:ss]
Event operation
This function is available as of system version 7.
Event operation has the highest priority of all three operating modes.
Parameter
Control signal
86
Selection/data input
-99999 to 99999 (100)
As of system version 7:
-1.7e+307 to 1.7e+307
Select unit
(No unit)
Inactive
Active
Linear
Logarithmic
Selection/data input
Select signal from selector
Enter text (or use existing text) Designation of the signal
Inactive
Active
Selection/data input
On
Off
00:00:01 to 24:00:00
(00:00:05)
Selection/data input
Select signal from selector
Description
Upper limit of display range
Value unit
As of system version 7, the unit of the input signal
is used.
If active:
Data evaluation: The original display parameters
are replaced by the display parameters used here.
Scaling of the y-axis
Linear
Logarithmic
Description
Digital signal (binary signal)
System version 5: Digital PLC outputs (binary val-
ues 001 to 120) or signal from the event list (cen-
tral detector: active after each new alarm, inactive
after acknowledgement).
As of system version 6: Additional digital signals
available (process values of the modules).
If active:
Data evaluation: The original designation is re-
placed by the designation used here.
Description
Activation of data recording
The data is recorded at the configured interval
Data recording is not active.
Recording interval
Time interval at which the values of the analog and
digital signals of the group are stored for evalua-
tion.
Description
Digital signal (binary signal) that starts (high ac-
tive) and stops event operation.
Advertisement
Table of Contents
