Table of Contents
Advertisement
Program channel
Parameter
Number of sec-
tions
Program section 1 to Program section 200
Process step
(procedural step)
(available as of
system version x)
Section time
(hh:mm:ss)
RS
(Repeat section)
Start section
NoC
(Number of cy-
cles)
Number of cycles
Setpoint value 01
to Setpoint value
30
Tol high
Tol low
Operating contact
01 to
Operating contact
32
Selection/data input
0 to 200
0 to 200
00:00:00 to 99:59:59
1 to 200
0 to 999
-1000000 to 1000000
The limits depend on the ad-
missible minimum and maxi-
mum setpoint values of the
program generator.
-1000000 to 1000000
(0)
The limits depend on the ad-
missible minimum and maxi-
mum upper limit of the
tolerance band for the program
generator.
-1000000 to 1000000
(0)
The limits depend on the ad-
missible minimum and maxi-
mum lower limit of the
tolerance band for the program
generator.
Off (FALSE)
On (TRUE)
5 Configuration
Description
Number of program sections that the program gen-
erator is to process.
The process step specifies the limits of the section
time and defines which setpoint values are avail-
able.
Duration of program section
As from system version x:
The section time must be within the limits specified
by the process step.
Number of the program section that is to be repeat-
ed together with the following sections.
Number of repetitions of a program section (or
multiple linked program sections)
Setpoint values in the program section
As from system version x:
Only the setpoint values approved in the process
step can be used.
Upper limit value for tolerance band monitoring of
setpoint value 01
Lower limit value for tolerance band monitoring of
setpoint value 01
Operating contacts in the program section
Operating contact is not active.
Operating contact is active.
83
Advertisement
Table of Contents
