Table of Contents
Advertisement
- Configure and activate connection to the database (datastore) (condition for data recording).
12. After creating the CODESYS application, transfer it to the setup project and close CODESYS if ap-
plicable.
13. Transfer the project to the CPU: Setup program > Project > Data transfer
a) Send the configuration (incl. CODESYS application) to the CPU ("Send to device").
NOTE!
For debugging in the CODESYS application, it is possible to connect "online" to the PLC. In this way, for
example, the states of variables can be checked or values can be changed without stopping the appli-
cation. Before CODESYS is started from the setup program, the option "Start to debug" must be activat-
ed. After that, the connection with the PLC can be established in the CODESYS programming
environment.
If the CODESYS application is changed while the PLC is running, the "Login with online change" option
must be selected in the CODESYS programming environment during transfer. If the change is to be re-
tained in the CPU during power off, the "Update boot application" option must also be activated.
NOTE!
Certain changes made to the configuration (e.g., changes to the hardware configuration) will cause the
CPU to restart.
Further information
The JUMO Help Center provides further information, especially on the following topics:
•
JUMO Cloud
•
JUMO smartWARE SCADA
•
JUMO smartWARE Evaluation (as of system version 6)
https://www.helpcenter-jumo.net
6 Startup
97
Advertisement
Table of Contents
