Table of Contents
Advertisement
Replacing the battery
1. Remove the old battery (C) from the holder and replace it with a new one of the same type (button
cell CR2032).
Closing the housing
1. Insert the front housing section into the rear housing section and ensure that both locking hooks en-
gage.
2. If applicable, place the central processing unit back on the top-hat rail. To do this, please follow the
instructions on installation previously provided in this document.
Starting up the system again
1. If applicable, connect the connecting cables (USB, LAN).
2. If applicable, attach the wired terminal strip COM.
3. Attach the wired terminal strip +24V/GND and fasten. Start up the system.
7 Annex
C
105
Advertisement
Table of Contents
