S-311
Warning: - Check electrical cables for damage.
- Check if the safety covers are in a good condition. Order or replace damaged covers.
- Keep your hands out from the needle space and cutting mechanism.
- Do not modify the machine in any way, which can eliminate its safety parts.
Caution: - Do not neglect periodic maintenance.
- If you have fault in electrical power supply, switch off the operating switch (circuit breaker).
- Do not damage, correct and remove safety labels.
- Do not work with the machine when you are under the influence of drugs or alcohol.
- User has to ensure the lighting of the working area minimal 750 Luxes.
1 . C L E A N I N G A N D M A I N T E N A N C E O F T H E M A C H I N E
1.1. Switch the power off and disconnect the air
supply.
1.2. For cleaning and maintenance, remove the
clamp feet by removing the protecting
latches . Lift the clamp feet and pull it to
the operator. Remove the locking screw
and fold the rear cover .
1.3. Clean the thread lints and fabric from the
sewing area - guides and thread tension. To
move the sewing mechanism, turn the hand
wheel . It is also possible to turn the race
by hand. The machine head can be raised to
the position where it is locked by a strut
which is controlled by a button .
By pressing the button , the machine can
lowered to the working position.
WA R N I N G ! Possible serious injury when
lowering the machine head.
1.4. Lubricate the machine according to the
section F4.
1.5. Check if the oil reservoir , under the
machine, is full. It is necessary to liquidate
used oil according to the environment
regulation.
1-66
F
- MACHINE MAINTENANCE
e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phones: +420 582 309 146 (Service); +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
Revised 02/2009