Adjustment Of The Bite Mechanism - AMF S-100 Parts And Service Manual

S-311
E
13. A D J U S T M E N T O F T H E B I T E M E C H A N I S M
S 311 machine is equipped with a mechanism to change electronically the width of buttonhole seaming. The
mechanism can be set up for 2 main seaming widths – 2,1mm and 2,7mm. Changing the values
electronically on the display, it is possible to modify the main width in the range of ± 0,3mm. The
mechanism adjustment is such:
13.1. To set the bite to 2,1mm (2,3 mm CT), loose the nut
to the end stop towards the edge of the stop
13.2. To set the bite to 2,7mm, loose the nut
to the end stop towards the edge of the stop
13.3. In case of 3,4mm bite, remove the right stop
of the machine. It is necessary to pull the stop to the right into the radius gap and guard it
with a screw. After this step, exchange the throatplate for this bite and adjust loopers again.
If the throatpalte is not exchanged, the machine can get damaged!
2,1 mm (AF, LTT)
2,3 mm (CT)
(Electronically
1
2
1-54
- STANDARD MACHINE ADJUSTMENT
0.0
± 0,3 mm)
4
3
e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phones: +420 582 309 146 (Service); +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
and move the pin
.
and move the pin to the right all the way
.
and use the stop supplied in the accessory
2,7 mm
(Electronically
to the left all the way
0.0
± 0,3 mm)
1
2
4
3
Revised 06/2007