The Bedplate Home Position Adjustment - AMF S-100 Parts And Service Manual

E
3. T H E B E D P L AT E H O M E P O S I T I O N A D J U S T M E N T
The bedplate home position is given by position of the plates ™,œ and sensor BQ2  for axes X and
BQ3 š for Y. Sensor plate screws are painted from the manufacturer, and only a service technician
from AMF REECE can perform this operation during the guarantee period .
3.1. Adjust the sensor plate ™ (BQ2)  after loosening the screws, ˜ to approximately 14 mm.
Remove the right cover of the bedplate ž to access to the plate ™.
3.2. After removing the left cover of the table – adjust the sensor (BQ3) š. Loosen the screws › to
obtain the 132,5 ± 0.2 mm from the shaft holder — to the plate edge - see picture. Belt holder is
set to 141 mm from the shaft holder —. The plate œ should be 32mm long.
3.3. The clearance between the sensor and plate must be 0.2 - 0.3mm. More clearance causes
improper sensor function.
3.4. Adjust the position of the sensor plate œ if the dimension from inner puncture in the eye top
and the centre needle is not 64mm. Approximately 154mm from the adge of the bedplate, see
section E8).
–
ž
š
Revised 04/2007
e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phones: +420 582 309 146 (Service); +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
- STANDARD MACHINE ADJUSTMENT
141 mm
132,5 ± 0.2 mm
œ ›
 š
œ
™
—
S-311
ž
–

™
1-43