Manual Cut Mode; Plc Adjustment By Machine Type - AMF S-100 Parts And Service Manual

S-311
14. E L E C T R O N I C S Y S T E M E R R O R M E S S A G E S
If an error message appears on the display, press it – – – – – The screen — — — — — with a description and a correction of
an error message appears on the display (see Troubleshooting).
1
E-01
15. M A N U A L C U T M O D E
The green button – – – – – outside of the control box, activates cutting independent
of the program. It may be used together with pressing the foot pedal to the first
position, so the clamps hold the fabric to check if the cut is clean.
P r o g r e s s : Insert the fabric under the clamp feet, switch the foot pedal into
the first position, hold this pedal in this position and press button – – – – – . Cutting
lever will cut the fabric everytime, when the button – is pressed. Then release
the foot pedal.

16. PLC ADJUSTMENT BY MACHINE TYPE

When changing PLC in the machine, it is necessary to adjust the potentiometer position by machine type we
are using. To adjust to required position, use the cross screwdriver. This adjustment is made on turned on
machine in the machine control box. It is necessary this operation is made by qualified person only!
1-40
D
- MACHINE CONTROLS
2
MACHINE TYPE ADJUSTMENT:
AF, CT, LTT, RDE
AF+I a CT +I
AF/ACL, LTT/ACL
e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phones: +420 582 309 146 (Service); +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
adjust to 28 (range 0-50)
adjust to 78 (range 51-A0)
adjust to C8 (range A1-FF)
Revised 02/2009