Mechanism Adjustment For Material Clamping - AMF S-100 Parts And Service Manual

S-311
E

6. MECHANISM ADJUSTMENT FOR MATERIAL CLAMPING

WA R N I N G ! Before doing any adjustments, disconnect
the air supply and deflate the test of compressed air in the
machine.
The basic clamp plates adjustment – with clamp feet —
is possible to modify after removing from the machine.
6.1. After loosening the screws ˜ adjust the clamp
feet— from front to rear (in the Y axis) and after
loosening the screws š from left to right
(in the X axis)
6.2. The adjust feet — clamp against the plates ž for
1,2 - 2,0mm overlap.
6.3. Remove the side table covers › by removing the
œ
screws .
6.4. Insert the clamp plates – into the machine.
6.5. Adjust the plates lift — for 12mm and after
loosing the screws ™ tighten them again.
6.6. Put the side table covers › on and screw them.
6.7. Check the proper adjustment when sewing.
Recommended space between the clamp foot and
needle during the outer penetration is 1 mm. If the bite
size is changed, ensure this space by covering the clamp
feet — over clamp plate ž - measure A to values. Adjust
after loosening the screw š and shifting the clamp plate
arm to the correct needed clearance.
œ
œ
Asymmetrical clamp
plates adjustment.
1-46
- STANDARD MACHINE ADJUSTMENT
›
™
e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
Phones: +420 582 309 146 (Service); +420 582 309 286 (Spare Parts); Fax: +420 582 360 606
™
—
ž
–
—
˜
˜
™
ž š
Revised 04/2007