D - Machine Controls; Operation - AMF S-100 Parts And Service Manual

S-311
1 . O P E R AT I O N
1.1. With the machine in the home position, before sewing, the manufacturer recommends 3 minutes
for warm up.
1.2. Be certain that the machine is threaded
correctly see section C3, and required
buttonhole appears on the display. Insert the
fabric under the clamp feet. Use the rear stops
– to position the buttonhole.
1.3. When the foot pedal — is pressed to the first
position, the fabric is clamped by the clamp
feet. (When the pedal is released, the clamp
feet rise.)
1.4. When the foot pedal is pressed to the its second
position, the sewing is started. When the buttonhole is sewn, fabric is cut and the upper thread
is trimmed, clamp feet rise and machine returns to its home position.
1.5. When the clamp feet are up, it is possible to move the fabric for sewing the next buttonhole.
1.6. Immediate stopping in any place of the cycle is possible by the EMERGENCY STOP
button ˜ on the machine head. If the EMERGENCY STOP is released, the machine stops
(the flaw E01, see manual section -
troubleshooting).
1.7. If the foot pedal — is pressed before the
buttonhole is finished, sewing cycle is interrupted,
the clamp feet will not rise and the needle will go
to the top position. The folowing screen will be
displayed: sewing cycle is finished by pressing the
pedal again.
NOTICE! Sewing cyccle continues after
pressing the pedal!
1.8. When your work is finished, switch off the switch
™ , pull out the plug š from the socket and
close the air supplyand close the air supply.
1-26
D
- MACHINE CONTROLS
e-mail: service@amfreece.cz; parts@amfreece.cz; website: www.amfreece.com
–
2 stitches backard
movement
Phone: +420 582 309 286; Fax: +420 582 360 606
2 stitches forward
movement
Revised 04/2010